All Products

Intended for removing dirt from units and mechanical device by compressed air flow. Equipped with a steel nozzle. It is eqquiped with quick connector ¼"Supplied in individual blister pack. Supplied in a blister packaging...

Intended for removing dirt from units and mechanical device by compressed air flow. Equipped with a steel nozzle. It is eqquiped with quick connector ¼"Supplied in individual blister pack. Supplied in a blister packaging...

Made of the chrome-vanadium tool steel by the hot stamping method (forging hammers). Has a standard open end profile and 12-point box end working profile. Ratchet mechanism of the box end profile with 72 teeth provides minimum working stroke of the wrench 5 °. Heat treated to hardness 39-41 HRC. ..

Made from chrome-vanadium steel by the cold stamping method. Has 6-point socket. Equipped with a hole 21 mm in diameter for the tap wrench. Protected against corrosion by the matt nickel-chromium coating...

Designed for using with a pneumatic impact tool. External 6-point working profile. Square drive 1/2". Made by the method of cold stamping. Socket material - chrome-molybdenum steel. Protected against corrosion by the chemical oxidation...

Made of S2 tool steel by the drawing method. Has a standard external hex working profile and a ball hex profile of the long arm. Heat treated to hardness 47-52 HRC. Protected against corrosion by the nickel-chromium coating with the matt surface effect...

Made of the chrome-vanadium tool steel by the hot stamping method (forging hammers). L-shaped wrench handle has a polymer coating which prevents palm slippage. Wrench has a standard hex working profile. Wrench working part is equipped with a retaining rubber insert. Protected against corrosion b..

Inserts are made by the cold stamping method of the S2 tool steel, hardened to 55-60 HRC and protected from corrosion by phosphatizing. External 12-point Spline inserts working profile. Inserts length - 75 mm. Bits operating size - М5, М6, М8, М10, М12. Individual packaging - a blister...

Made by hot stamping (forging hammers). Material – chrome-vanadium tool steel 31CrV3. Hardened to 43-45 HRC. Has comfortable ergonomic rubberized handles. It is eqquiped with pullback spring. Protected against corrosion by phosphatizing...

The holder is used in small hand drills and column (table) drills. Minimum jaw spacing: 2.0 mm. Maximum jaw spacing: 13 mm...

Used for rewinding brake calipers of cars with a disk brake system. Has a reinforced thread. Used as an independent device or as a spare part for restoration the working productivity and expanding the usage the brake caliper rewind tool sets. Comes stored and orginized in a individual blister pac..

Made of the chrome-vanadium tool steel by the hot stamping method (forging hammers). Has a standard open end profile and 12-point box end working profile. Ratchet mechanism of the box end profile with 72 teeth provides minimum working stroke of the wrench 5 °. Swivel allows you to change the angl..