All Products

Used for removing and installing engine oil filters without damaging them, for installing filters with a torque wrench complying with technical requirements of automakers. Equipped with 1/2" (12.5 mm) square drive for the tap wrench. Made of 45 steel by the hot stamping method (forging hammers). ..

Used for removing and installing engine oil filters without damaging them, for installing filters with a torque wrench complying with technical requirements of automakers. Equipped with 1/2" (12.5 mm) square drive for the tap wrench. Made of 45 steel by the hot stamping method (forging hammers). ..

Set is intended to restore the internal thread. Restoration is carried out by screwing in spring thread bit. Set contain a drill, tap, driver pin for thread bits installation, pin punch for snapping off adjusting end and 12 bits. Bits are made from stainless steel. Set includes inserts with one ..

Mechanism with 72 teeth allows to rotate by 5 degree minimum angle. Equipped with a flag switch, a quick-reset button and a holding ball. Made by cold stamping method. Material - chrome-vanadium steel CrV50BV30. It is hardened to hardness not less than 39HRC. It is chrome plated and matt finis..

Wrench with increased jaw spacing (compared to standard wrenches of this size). Made of chromium vanadium steel (CR-V), the chromium used guarantees the steel's resistance to corrosion, oxidation, abrasion and high strength at high temperatures, while the addition of vanadium also affects resistanc..

Iimproved type grease gun has head zinc coating and housing chromium coating. Supplied with a metal tube and four lug coupling. In the grease gun design is used steel and cast iron which provides high working pressure, increases the durability and allows to use the grease gun in cases of a strong ..

Working profile - external Torx®. Individual packaging - plastic case...

Set is equipped with a steel rail with lug socket holders. Comes stored and orginized in a individual blister pack...

Mechanism with 45 teeth allows turning with 8 degrees minimum angle. Equipped with a flag switch, a quick-reset button and a holding ball. Made by cold stamping method. Material - chrome-vanadium steel CrV50BV30. It is hardened to hardness not less than 39HRC. It is chrome plated and matt fini..

Working profile - external Torx®. Set is equipped with a steel rail with lug socket holders. Comes stored and orginized in a individual blister pack...

They are used for crimping wire non-insulated terminals during electrical installation works. Working profiles of high accuracy and automatic control of the pressing force ensure high crimping quality. Working part is made of tool steel with subsequent hardening to 44-47 HRC. Pliers are equipped ..

They are used for crimping wire non-insulated terminals during electrical installation works. Working profiles of high accuracy and automatic control of the pressing force ensure high crimping quality. Working part is made of tool steel with subsequent hardening to 44-47 HRC. Pliers are equipped ..