All Products

Made of the chrome-vanadium tool steel by the hot stamping method. Has a standard open end profile and OVER DRIVE box end working profile. Spanner heads are made with high accuracy and hardened to 39-41 HRC. 75 degrees offset of the box end profile relatively to the wrench surface provides more c..

Hammer head is made of 45 steel by the hot stamping method (forging hammers). Impact hardness - 44-48 HRC. Square-shaped hammer head with flat and pointed impact parts. Hammer handle is made of fiberglass and has a high mechanical strength and resistance to aggressive medium. Handle is equipped ..

Hammer head is made of 45 steel by the hot stamping method (forging hammers). Impact hardness - 44-48 HRC. Square-shaped hammer head with flat and pointed impact parts. Hammer handle is made of fiberglass and has a high mechanical strength and resistance to aggressive medium. Handle is equipped ..

6-point operating profile. Made by the method of cold stamping. Material - chrome-vanadium tool steel CrV50BV30. Hardened to 45-47 HRC. Protected from corrosion by chrome plating...

Предназначен для контроля автомобильной бортовой сети с напряжением 6, 12 или 24 В. Укомплектован проводом с зажимом “крокодил”. Может быть подключен в любом месте электропроводки. Indication is carried out by a lamp glow,. Comes stored and orginized in a individual blister pack...

Предназначен для контроля автомобильной бортовой сети с напряжением 6, 12 или 24 В. Укомплектован проводом с зажимом “крокодил”. Может быть подключен в любом месте электропроводки. Indication is carried out by a lamp glow,. Comes stored and orginized in a individual blister pack...

6-point operating profile. Made by the method of cold stamping. Material - chrome-vanadium tool steel CrV50BV30. Hardened to 45-47 HRC. Protected from corrosion by chrome plating...

Used for cutting of soft copper and aluminum pipes of brake system. Intended for pipes from 3 to 28 mm in diameter. Includes round cutting knife and adjusting screw with two support rollers. Body is made by the precision casting method. Comes stored and orginized in a individual blister pack...

Intended for straightening sheet metal during body repair works. Impact part is made of thick rubber resistant to aggressive technical liquids. Handle is made of fiberglass and has a high mechanical strength. Handle is equipped with rubber pads to soften the impact and ease of grip...

Tap wrench head is made by the cold stamping method and equipped with a spring-loaded retaining ball. Material - chrome-vanadium tool steel CrV50BV30. It is hardened to hardness not less than 39HRC. Wear-resistant, suitable for the long-term usage at max loads. It is chrome plated and matt fini..

Used for tapping of internal thread in blind and through holes with tap holder. Material - high-speed steel HSS4341. Hardened to 62-64 HRC. Set consists of 2 taps with reduced size and complete thread profile size. Packaging - plastic case...

Set is equipped with Torx® keys standard length packed on a plastic holder. Individual packaging - a blister...