All Products

Working profile - internal Torx®. Made by the method of cold stamping. Material - chrome-vanadium tool steel CrV50BV30. Hardened to 45-47 HRC. Protected from corrosion by chrome plating...

Flat brush is designed to clean metal, wood and plastic surfaces from old paint, dirt and corrosion. Steel reinforced pile of the twisted brush. Wire diameter - 0.5 mm. Connecting thread for installation on angle grinders - M14*2.0 mm. Maximum brush rotation speed - 12500 rpm. Delivered in indi..

Made of the chrome-vanadium tool steel by the hot stamping method (forging hammers). Has a standard open end profile and 12-point box end working profile. Ratchet mechanism of the box end profile with 72 teeth provides minimum working stroke of the wrench 5 °. Swivel allows you to change the angl..

Designed for using with a pneumatic impact tool or wrenches with a torque amplifier. Internal 4-point working profile for the dismounting of wheel fittings. Made by hot stamping (forging hammers). Socket material - chrome-molybdenum steel. Protected against corrosion by phosphatizing...

12-point sockets. Made by the method of cold stamping. Material - chrome-vanadium tool steel CrV50BV30. Hardened to 45-47 HRC. Equipped with a holding magnetic insert. Protected from corrosion by chrome plating...

Insert with Torx® external working profile. Socket is made by cold stamping method. Material – chrome-vanadium steel CrV50BV30. Hardened to 45-47 HRC. Material of inserts -S2 tool steel S2. Wear-resistant, suitable for the long-term usage at max loads. Socket is chrome plated with matte surfac..

Used to measure the compression of VAZ 2101-099 engines and engines with not deep plug boxes. Manometer with a diameter 51 mm has a measurement limit 16 kgf/cm². Equipped with an aluminum bar 130 mm long with knurling, threaded tip, pressure relief valve and conical rubber nozzle. Thread size - M..

Insert with Torx® external working profile. Socket is made by cold stamping method. Material – chrome-vanadium steel CrV50BV30. Hardened to 45-47 HRC. Material of inserts -S2 tool steel S2. Wear-resistant, suitable for the long-term usage at max loads. Socket is chrome plated with matte surfac..

Flat brush is designed to clean metal, wood and plastic surfaces from old paint, dirt and corrosion. Brush bristle has brass coating. Wire diameter - 0.3 mm. Connecting thread for installation on angle grinders - M14*2.0 mm. Maximum brush rotation speed - 12500 rpm. Delivered in individual card..

Flat brush is designed to clean metal, wood and plastic surfaces from old paint, dirt and corrosion. Brush bristle has brass coating. Wire diameter - 0.3 mm. Connecting thread for installation on angle grinders - M14*2.0 mm. Maximum brush rotation speed - 12500 rpm. Delivered in individual card..

Intended for ignition coils dismantling of VAG. Intended for 8 and 12 cylinder engines VW Phaeton, B5 1.8T, GTI, FSI 2.0. Puller gripper design allows to dismantle carefully the ignition coil without damaging it. Working part of the puller is made of chrome-vanadium tool steel, hardened and prote..

Intended for ignition coils dismantling of VAG. Intended for VW Bora, Golf, Passat, Sharan, Touareg, R32, Phaeton, T5, V5 2.3, V6 3.2. Puller gripper design allows to dismantle carefully the ignition coil without damaging it. Working part of the puller is made of chrome-vanadium tool steel, harde..